Prerequisite
The Scanning Engaging Locators
procedure must be completed.
Consider using the Advanced Settings before scanning an
object.
Replace the soft tissue that was removed for the locator scanning. Remember, soft
tissue material should be sprayed with a CAD spray so it can be detected by the
scanner.
Steps
-
From the Scan
list, click Upper or Lower
depending on the type of jaw being scanned.
-
Set the blue rectangle over the area of the model you wish to scan including
emergence profiles, adjacent teeth, etc.
Note:
Consider rotating the mouse wheel to increase the size of the blue rectangle
to fully cover the implants and adjacent teeth. You can add points to
the rectangle by clicking on the central line running through the
rectangle.
-
Click Scan.
Note:
Scanning can take several minutes.
-
When scanning is completed, from the Scan View, rotate the
scan in all orientations to check the presence of holes.
-
From the Restoration List list,
select a shade and material for each restoration.
-
Complete patient, technician, identifier and dentist information.
-
Click Finish.
Result
A situation is created with the scan. The situation is sent to the NobelProcera
Abutment module where
the Standard CAD abutment can be designed.