Improvement Options

Prerequisite

Scanning must be completed.

Scan must be displayed in the Scan View.

From the Scan View, rotate the scan in all orientations to check if all object surfaces are scanned properly.
The procedure to perform will differ depending on the state of the scan in the Scan View:
1. If all areas of the object appear on the scan, continue to the next step of your procedure.
2. If a few areas of the object do not appear on the scan, perform the Adding a Scan procedure.
3. If the scan is missing several areas of the object, perform the Rescanning an Object procedure.
4. If the scan bears holes or incomplete areas, use the Mesh Edition Tools to repair the scan.
5. If the scan has excess matter, use the Mesh Edition Tools to trim and cut off the scan.