Scanning a Cutback Coping

Prerequisite

The Mounting an Object on the Scanning Table within the Scanning Range step must be completed.

Consider using the Advanced Settings before scanning an object.

Steps

  1. From the Crown and Bridge section, click Cutback.
  2. In the Situation Manager, select the tooth number of the preparation.
  3. Click Adjacent.
  4. In the Situation Manager, select the adjacent teeth.
  5. In the Camera View, align the numbered blue circles over their corresponding unit.
  6. Click Scan.
    Note:

    Scanning can take several minutes.

  7. Follow displayed instructions.
    Note:

    Steps 8 and 9 can be completed while scanning is being carried out.

  8. From the Restoration List, select a material type and a shade for the restoration.
  9. Complete the information on patient, identifier, dentist and technician.
    Note:

    Consider Improvement Options before proceeding to the next step.

  10. Fit the bite index on the model.
    Note: If you do not have the bite index, proceed to the last step. Bite index scanning is optional but is recommended for better results.
  11. Click Bite index.
  12. In the Situation Manager, select the teeth covered by the bite index.
  13. In the Camera View, set the blue rectangle over the teeth covered by the bite index.
  14. Click Scan
    Note:

    Consider Improvement Options before proceeding to the next step.

  15. Click Finish.

Result

A situation is created with the scan. The situation is sent to the NobelProcera Crown and Bridge module where the Cutback coping can be designed.