Mounting an Object on the Scanning Table within the Scanning Range

Prerequisite

Object must be securely set on the scanning table.

Remember to take into account all the elements that are required to scan the object i.e. locators, bite index etc.

For large objects, you may need to ignore the height validation message and add scans of different regions of the object.

Steps

  1. Set the ruler on the scanner platform.
  2. Using the height adjustment screw, set the scanning table to the proper height.
    Note:

    The upper part of the object must be below the maximum limit of the ruler.

    The lower part of the object must be higher than the minimum limit of the ruler.

Result

The scan passes the height validation step and completes normally.