Position of reslices

When there is the need for showing a different part of the model, repositioning the reslices in the model might be needed. The position of the coronal, sagittal or axial reslices with regard to the patient and surgery models can be adjusted easily by dragging the sliders in the respective 2D viewers or by using the right-click menu of the reslice in the 3D viewer.

2D

Drag the slider at the right-hand side of the 2D viewer up or down to reposition the reslice in the model.

Tip

If you wish to monitor the movements of the reslice in the 3D model as well, make sure that the visibility of the reslice is switched on in the Patient visibility panel.

3D

Should you wish to reposition a reslice in the 3D Viewer, make sure to show the reslice(s) in the Patient Visibility smart panel.

In the 3D Viewer, right-click on the reslice.

In the pop-up menu, select Slice Number.

Now drag the slider to adjust the slice number. Alternatively, enter a value directly or use the arrows to go to the correct position.