For adding a multiple-tooth restoration to your treatment plan, either define the bridge or the bar first, or begin with the interfaces and put the bridge or the bar on top afterwards.
Select a range of teeth by dragging a box over multiple tooth numbers or over multiple teeth in the tooth chart.
Select a restoration type. The restoration types are filtered according to your selection. If you select a range of teeth, you will only see the multiple-tooth restoration types.
Note
Which products are available, is dependent on:
The released products in your country and the version you are working with
For in-lab products: the registered production devices in combination with the parameter files.
The restoration details are shown on the right-hand panel.
If applicable, select the production method: Nobel Biocare production or In-lab milling. Then select the design parameters like Material.
Note
The last selected parameters become the default parameters.
Click on the tooth or the tooth number where to place the interface.
Select an interface type.
For an abutment or an implant, select the Diameter. For implants you will also have to select a Connection.
Repeat steps 5 to 7 until all interfaces have been indicated.
Click Finish.
Note
If fewer than two interfaces are selected for the implant bridge or the bar, an error message will occur.
Click on the tooth or the tooth number in the tooth chart where to place the interface.
Next, click on the Interfaces tab and select the interface type.
For an abutment or an implant, select the Diameter. For implants you will also have to select a Connection.
Then select a range of teeth that covers the interfaces by dragging a box over multiple tooth numbers or over multiple teeth in the tooth chart.
Select a bridge or a bar. The bridge types are filtered according to the planned interfaces.
Select the design parameters.
Note
If not all the interfaces in the treatment plan are connected to a bridge or a bar, an error message will occur.